Note
Before you begin, identify your bracket type (AI-14 Mounting Bracket V1 orAI-14 Mounting Bracket V2) and click the appropriate link:
To install your AI-14 Dash cam with the AI-14 Mounting Bracket V1, slide the unit into the standard mounting bracket from the right side and until it locks into place with two locating tabs.
Important
Leave 12.5 cm (4.9 inches) to the right of the dash cam to allow room to insert it into the bracket.
Select and Prepare the AI-14 Mounting Bracket V1 Location:
-
Choose a windshield location that does not obstruct your view, vehicle controls, or the Supplemental Restraint System Deployment (SRS).
-
Temporarily position the dash cam to confirm clear views, then mark the spot.
-
Clean the marked area thoroughly with the alcohol wipe and let it dry completely.
Attach the dash cam to the AI-14 Mounting Bracket V1:
-
Peel off the adhesive cover.
-
Carefully align the mounting bracket with your marked spot and apply even pressure, rolling it onto the windshield from top to bottom.
-
Smooth out any large air bubbles by applying more pressure. If necessary, use a small pin to release trapped air.
-
Allow the mounting bracket to cure for at least 10 minutes before attaching the dash cam.
Secure and verify the dash cam:
-
Power off the dash cam.
-
Slide the AI-14 Dash cam body into the mounting bracket from the right until it clicks into place.
-
Power on the dash cam, access "Live View," and verify clear in-cabin and road lens views.
-
Secure the Torx T6 where the mounting bracket meets the dash cam body to lock the views.
Note
Do not overtighten. The T6 has a torque specification of 0.8 Nm.
Click here to return to the unboxing section.
To install your AI-14 Dashcam with the AI-14 Mounting Bracket V2, insert the unit vertically and secure it via two locating tabs and two Torx T6 screws.
Attach the dash cam to the AI-14 Mounting Bracket V2:
-
Unscrew the two T6 mount screws to free the windshield mount,
-
Release the AI-14 Mounting Bracket V2 mounting,
-
Press in the two locking tabs.
-
Slide the AI-14 body and mounting foot down from the windshield mount.
-
Choose a windshield location that avoids obstructing your view, vehicle controls, or the Supplemental Restraint System (SRS).
-
Clean the marked area thoroughly with an alcohol wipe and let it dry.
-
Remove the adhesive cover. Align the mounting bracket and apply pressure with a plastic trim tool, rolling it onto the windshield. Smooth out any air bubbles.
-
Allow the mounting bracket to cure for at least 10 minutes before proceeding.
Secure and Verify the Dash cam:
-
Power off your AI-14 Dash cam.
-
Slide the dash cam body upwards into the universal mounting bracket until the locating tabs click.
-
Tighten both the left and right Torx T6 screws (0.8 Nm torque specification) to secure the dash cam.
-
Power on the AI-14, access "Live View," and confirm clear in-cabin and road lens views.
-
Secure the Torx T6 where the mounting bracket meets the dash cam body to lock the views.
Note
Do not overtighten. The T6 has a torque specification of 0.8 Nm.
Click here to return to the unboxing section.