This section outlines the steps to prepare and unbox your AI-14 dash cam. Please make sure you have all the necessary components before proceeding with the installation.
You will find the following items in the AI-14 dash cam box: The AI-14 dash cam, with the pre-installed SIM and Micro-SD cards, the mounting bracket, the QR code to access the installation instructions, a T6 Torx Wrench, alcohol wipes, and the notification window sticker.
Note
Before proceeding, locate the International Mobile Equipment Identity (IMEI) number for your AI-14 dash cam. This number is crucial for device setup and for receiving technical support. You can find the IMEI number on a sticker directly on the dash cam unit and on the back of the dash cam's packaging box.
Additional Items Not Included in the Kit
The following items are necessary for the installation and operation of your AI-14 dash cam. You can purchase them using the Lytx Surfsight AI-14 Standard Price List order form.
-
AI-14 Standard Power Cable (Hardwire)
This power cable is used to hardwire the dash cam directly into your vehicle's power source.
-
OBD II/Power Only Y-cable, AI-14
This cable connects the dash cam to your vehicle's On-Board Diagnostics (OBD) port, while leaving the port open for other functions.
-
IOX/AI-14 IOX
This cable connects the IOX port on a Geotab Go device to the AI-14 Molex connector.
Note
The AI-14 requires a 12 V or 24 V power source.
Required Tools
Before you begin installation, make sure you have reviewed all guides and have the following tools on hand:
|
Wire Cutter |
Cloth Tape |
|
Wire Crimper |
Electric tape |
|
Voltmeter or MultiMeter |
Assorted Self-Sealing Crimp Connectors |
|
Vehicle panel removal tool |
Tape measure (5 Meter/ 16 ft) |
|
Screwdriver set |
Marking pen |
|
Flat-blade screwdriver |
T-8 security Torx bit |
|
Cable ties |
Vehicle manufacturer recommended tools |
|
Zip/Cable Ties |
Mobile device with access to the Internet |
|
Phillips screwdriver |
|
Note
Refer to the manufacturer's manual to find any special tools or parts required for maintenance, service, installation, or diagnostics.
Optional Tools
The following tools are not required for installation, but they may improve efficiency and ease of use.
|
Cordless driver |
Utility knife |
|
Add-a-circuits or vehicle-specific connectors |
Vehicle-specific panel clips |
|
Grommets and looms |
Heating torch |
|
Flashlight |
Heat shrink |
|
Paper towels/shop towel |
Self-amalgamating tape |
Identify Your Mounting Bracket
Your AI-14 dash cam kit includes either an AI-14 Mounting Bracket V1 or an AI-14 Mounting Bracket V2. Identify which bracket you have and follow the installation steps designed for the specific bracket. To determine your bracket type, examine the mounting bracket included in your box:
-
AI-14 Mounting Bracket V1
The dash cam slides into this mounting bracket from the right side and locks into place with two locating tabs.
Click here for the installation instructions: AI-14 Mounting Bracket V1
-
AI-14 Mounting Bracket V2:
The dash cam slides into this mounting bracket vertically and uses two Torx T6 screws to secure it in place.
Click here for the installation instructions: AI-14 Mounting Bracket V2