Connect the AI-12 dashcam to a power source

To utilize the full features of the AI-12 dashcam, including Standby mode, your dashcam must be connected to a constant 12V or 24V minimum 2A power source. The dashcam should only be connected to a power source using the supplied cables.

If an installation is aborted and the dashcam has power, follow the power off procedure to avoid draining the battery. See Power off or restart the dashcam.

The input power connector is located on the side of the dashcam cylinder.

vehicleFuseBox_connectToPowerSource

Note

USB-C can NOT be used to power the dashcam.

You can connect the dashcam to a power source as follows:

When you connect the dashcam to a power source, position the cable as shown.

dashcam-cable-correct.jpg
Was this article helpful?
0 out of 0 found this helpful