Note
The dashcam will be prevented from powering-up unless its internal battery charge level reaches a certain percentage. The dashcam internal battery may be discharged if it has been previously used and its electrical installation was incorrect (e.g., if there were recurrent voltage drops), if it has been stored for a long time in a warehouse. In these scenarios, if the dashcam's internal battery is discharged, it will be necessary to fully recharge it by connecting the dashcam to a 2A constant source of power for 30 to 60 minutes.
-
Read and follow the instructions and precautions in the Surfsight User Guide, the Surfsight Help center (https://kb.surfsight.net/hc/en-us) and the warnings set forth below when installing the Surfsight dashcam.
-
Always refer to the vehicle manufacturer’s service manual/ up-fitter (body builder) sites for proper installation and wiring of any aftermarket devices, including the Surfsight A1-12 dashcam. Failure to do so may result in property damage and/or personal injury.
-
Read and observe all warnings, cautions, and safety notices in the instructions and procedures. They provide information to avoid serious personal injury, damage to components or both.
-
Follow the vehicle’s maintenance, service, installation, and diagnostic guidelines provided by the manufacturer of the vehicle.
-
Use special tools and safety equipment to avoid serious personal injury and damage to components.
Important
THIS GUIDE IS NOT A SUBSTITUTE FOR A QUALIFIED TECHNICIAN. This guide is designed to be used in conjunction with the Surfsight Help center (https://kb.surfsight.net/hc/en-us ) and Surfsight AI-12 Installation guidance and related documents.
Note
THE DEVICE SHOULD NOT INTERFERE WITH THE VEHICLE'S NORMAL OPERATION OR VEHICLE SYSTEMS.